Condensing Unit Equipment Replacement Modifications In Cypress, TX

Reclaim: Removal of all refrigerant in the existing system.

Disposal: Dispose of the failed unit at the property and the dispose of the reclaimed Freon up to EPA required standards.

Slab: Properly sized concrete pad under the new outside condensing unit to keep the unit off the ground and to protect it from dirt, debris and standing water.

Whip: High voltage electrical wiring connected from service disconnect to condenser in proper conduit.

Service Disconnect: Installed within sight of the unit, allows power to be turned off to the unit for safe servicing.

Service Breaker: Installed inside of the service disconnect, breaker size is determined by the required minimum and maximum rating amperage of the new condenser.

Low Voltage Conduit: Protects the low voltage wires running from thermostat to condenser, the wires fit inside conduit.

Line Set Modification: Modifying copper lines from wall to condenser to fit properly and neatly.

Armoflex Line Insulation: Insulate Freon lines to prevent weathering or condensation from leaking on ceiling or in walls.

Start Kit: Adds electric boost on compressor when starting, causes less stress on compressor which can prolong the life of the unit.

Liquid Line Drier: Used to stop small debris in lines from getting into coil and causing restriction at TXV or piston.

R-410A Conversion: Converting the existing system from the phased-out R-22 refrigerant to the new environmentally safe R-410A refrigerant.